Loader

AUTO REPAIR

Some of the fluids coming out of your transmission can be normal, but there are others that should be checked. If you notice any of these symptoms and see that your fluid is not what it should be, then you need to bring your vehicle in for a diagnostic check up.

Cleaning a car is a pain, especially if you have kids who spill food and drinks on the seats. Having a baby in a vehicle makes it even more difficult because children's baby gear is notorious for getting dirty and staining seats. Luckily, there are some techniques you can use to get stains out of car seats that will have your car looking new again.

Car shaking during acceleration is a very common concern among car owners. The car shakes the most when accelerating from a complete stop. However, I have noticed that it seems to shake less if I accelerate up to 10 MPH before accelerating smoothly toward my destination.

Starting a car with a bad starter can be really difficult because of many reasons. One of them is the fact that it takes more time to start a car with a bad starter. The starting process can take even several minutes, which can cause irritation for both you and other drivers on the road.

It is common for a fan clutch stuck engaged in the engine compartment of a car. This can happen when the fan is not spinning at all or when it is spinning too fast. Either way there is no air flow and this will cause your car's temperature to rise quickly. The only solution to this problem is to take your car into an auto shop and let them remove the fan clutch from under the hood.

The variable-assist power steering in a car assists the driver when initially turning the steering wheel. When the steering wheel is released, power assist reduces, allowing the driver to maintain control of the vehicle over rough road surfaces. Variable assist power steering in cars has been offered as an option on several makes and models by General Motors, Ford Motor Company, Chrysler Corporation, DaimlerChrysler, Volkswagen, Audi AG and Nissan.

There may be many reasons for the obd2 port no power. The most obvious is that the car battery was disconnected or died (or battery terminals were not connected). Whatever the reason, the following are some temporary workarounds you can try without any other hardware tools.

Your car's injectors can become clogged and not allow fuel to pass through the system resulting in a lack of power and performance. The following article discusses some common areas where debris may get trapped, causing an injector pulse problem. Have you been noticed what causes no injector pulse? A few simple diagnostic steps will help pinpoint the exact location of this issue.

It is important to reset the check engine light after you have made the repairs that caused the light to come on. This way you can know if the light comes on because of a new problem in your car. Modern vehicles make our lives easier and easier and with all the technology that manufacturers have added to them, they can already tell us through their computers when something is wrong in your car and when it is time to do the monthly maintenance of the vehicle. Here, I will present how to reset service engine soon light?